Design Submission

When you send design(s), it is suggested to follow our instructions below, including step A), B) and C) as it will make your order process smoothly therefore ensure a high quality of the delivery

Step A) Prepare your design(s) according to the following situations

- Order 1: for Fabric Printing

* Case 1: A pattern is printed in the full width and continuously printed in the length direction, which we call a Yard Repeat and is labeled REPEAT 1

Design Size:

- The maximum pattern width is the fabric width you ordered, which is informed in each product ordering page.

- The pattern length is the number of meters that you want. If you will have same pattern repeatedly printed in the multiple meters, you just need to submit one single pattern and we will do repeat printing.

* Case 2: One pattern is printed repeatedly in certain layout as showing below.

REPEAT 2 REPEAT 3 REPEAT 4

If you want to have a block repeat (REPEAT 2), make sure the pattern is repeatable, which means that no seam will show in the joint of patterns.

Besides telling the total length that you want, you should point out the type of repeat from one of the printing methods labeled above from REPEAT 1, REPEAT 2 , REPEAT 3, and REPEAT 4 so we know how you want this pattern to be continuously printed.

Step B) Generate your design(s) with the following requirements

- File Format: Tiff or Jpg

- Color Mode: CMYK is preferred but RGB is acceptable

- Resolution: 150-300dpi

- File Size Limit: 400MB with less than 0.3 billion pixels

- Design Size:

If it is for making scarf, please see the design size requirement on the right side in the Point 3.

If it is for fabric printing, please see the Design Size in the case 1 above.

Step C) Send your design(s) to info@silkmelody.com by uploading designs to a public server, such as www.wetransfer.com or www.dropbox.com. We will write to you a confirmation email for the design receipt.

- Order 2: for Making Scarf

There are three points included in the section.

Point 1: Signature position

To avoid the signature to be cut after hemming, the signature position should leave the edge at least for 1" (2.5cm ) before hemming.

Point 2: Minimum border width

Our standard border width BEFORE HEMMING would be one of the following options. Please make the border width according to your choice.